By running a light emitting diode (LED) with electrodes reversed, the team says they were able to cool another device mere nanometers away.
The team harnessed the chemical potential of thermal radiation. "Many assume that the chemical potential is zero, but theoretical work going back to the 1980s suggests that under some conditions this is not the case," contends Professor Edgar Meyhofer of Michigan.
The chemical potential in a battery, for instance, drives an electric current when put into a device. Inside the battery, metal ions want to flow to the other side because they can get rid of some energy and that energy is used as electricity. Electromagnetic radiation, including visible light and infrared thermal radiation, typically does not have this type of potential.
"Usually for thermal radiation, the intensity only depends on temperature, but we actually have an additional knob to control this radiation, which makes the cooling we investigate possible," said Linxiao Zhu, a research fellow in mechanical engineering and the lead author on the work.
That knob is electrical. In theory, reversing the positive and negative electrical connections on an infrared LED won't just stop it from emitting light, but will actually suppress the thermal radiation that it should be producing just because it's at room temperature.
"The LED, with this reverse bias trick, behaves as if it were at a lower temperature," Professor Pramod Reddy, who co-led the study with Prof. Meyhofer, said.
However, measuring this cooling - and proving that anything interesting happened - is complicated.
To get enough infrared light to flow from an object into the LED, the two would have to be extremely close together (less than a single wavelength of infrared light). This is necessary to take advantage of "near field" or "evanescent coupling" effects, which enable more infrared photons, or particles of light, to cross from the object to be cooled into the LED.
Reddy and Meyhofer's team had already been heating and cooling nanoscale devices, arranging them so that they were only a few tens of nanometers apart. At this close proximity, a photon that would not have escaped the object to be cooled can pass into the LED, almost as if the gap between them did not exist. And the team had access to an ultra-low vibration laboratory where measurements of objects separated by nanometers become feasible because vibrations, such as those from footsteps by others in the building, are dramatically reduced.
The group proved the principle by building a minuscule calorimeter, which is a device that measures changes in energy, and putting it next to a tiny LED about the size of a grain of rice. These two were constantly emitting and receiving thermal photons from each other and elsewhere in their environments.
"Any object that is at room temperature is emitting light. A night vision camera is basically capturing the infrared light that is coming from a warm body," Prof. Meyhofer said.
But once the LED is reverse biased, it began acting as a very low temperature object, absorbing photons from the calorimeter. At the same time, the gap prevents heat from traveling back into the calorimeter via conduction, resulting in a cooling effect.
The team demonstrated cooling of 6 watts per meter squared. Theoretically, this effect could produce cooling equivalent to 1,000 watts per meter squared, or about the power of sunshine on Earth's surface.
The team say this could be important with regards to future smartphones and other computers. With more computing power in smaller and smaller devices, removing the heat from the microprocessor is beginning to limit how much power can be squeezed into a given space.
With improvements of the efficiency and cooling rates of this new approach, the team envisions this phenomenon as a way to quickly draw heat away from microprocessors in devices. It could even stand up to the abuses endured by smartphones, as nanoscale spacers could provide the separation between microprocessor and LED.
